This Controller is a digital thermostat with a temperature range of 0-50°C. The permanent temperature display also allows its use as thermometer.
Heaters of up to 1000W can be connected through a coupling. A second coupling is controlled through an integrated timer.
It can be used to set operating hours for lighting or ventilators. The external sensor can measure in water and air.
In addition the Controller has an alarm function which warns optically and acoustically if the measured temperature is too high or too low (value can be set).
Overall a device that should not be missing in any terrarium!
Distinguish : 0.1°c
Temperature difference :1°c
Over heat alarm:±2°c
Time unit: hour
The heater is protected by sensor’s power off when water
Press key “TEMP”for 3s to blink the current temperature . Press key”∧”to increase 1,press key”∨”to decrease 1.Setting range: 16~36°c. Press key “TEMP” again for 3s to save and exit when finishing setting. Return to display the current temperature automatically and do not save the changing value if no operation for 15 seconds.
Time setting of timer:
Press key “TIME” for 3s to blink the current setting opening time, at the same time it will display” “on bottom of the first number pipe. Press key “∧ “or “∨”to change the original setting value, setting range :0~24H. press key “TIME” again to blink the current setting stopping time and it will display “” underside the first number pipe simultaneously. Press key”∧ “or “∨ ” to change the original setting value, setting range:0-24H(eg,15 means that 15 hours,not 15:00) Press key “TIME” for 3s to exist and save the setting value simultaneously. Return to display the current temperature automatically and do not save the changing value if no operation for 15s.
Check the setting temperature:
Press key”TEMP”to display the current temperature value and it will exist automatically after 2 s.
Check the setting time:
Press key ” ∧ “to display the current opening time ,press key”∨”to display the stopping time and then exist automatically.
Power on/off timer forcibly:
In normal measuring and control mode , press key “TIME”, power the timer, press key “TIME” again to power off,Cycle like this.
press any key to cancel the out of limit alarm,sensor’s failure alarm can not be cancelled
press key “∧ ” and”∨” together for 3 s to open or close out of limit alarm. Alarm on will remind you by “B_o”; alarm sound closure will remind you by “B_C”. Display delays for 2S and then exits.
Alarm when out of setting measuring temperature : actual ≤setting value -2°c or ≥setting value +2 °c, and then temperature value will blink and make an alarm sound “DIDI”
Alarm when out of measuring range : the actual temperature ≤0°c,display “LLL”; ≥50°c ,display “HHH”; make an alarm sound “DIDI”
Alarm for sensor’s failure ,display”EEE”, cut off the heater, make an alarm sound “DIDI”
Power off when water
Socket output controls load I is heating stick,is timer output connected with light or oxygen pump